- Euklid - CAD/CAM - EN »
- Products »
- EUKLID CAD/CAM »
- CAM »
- 2.5-Axis »
- Drilling and milling cycles
Drilling and milling cycles
EUKLID supports the drilling and milling cycles offered by the NC-control.
A wide range of drilling and milling cycles are available:
Drilling, counterboring, countersinking, deep drilling, reaming, thread cutting, rectangular pocket
smilling and circular pocket milling (G73, G81, G82, G83, G84, G85, G86, G87, G89).
If an NC-control ignores a cycle, the postprocessor will create the necessary commands (known by the NC-command) for this cycle.
Hint: See Drilling Features.